NEWS AND CHANGES
Firmware: FW 152/52
Instalator and configuration
| • | Required subscription 2017 |
| • | Utility for setup of function result form and automated saving data to the cloud |
| • | Backups of every file in folder CARSOFT/DATA (bínary files) are marked with VIN of the car (faster search) |
| • | Utility Technoid renewed (control of function result confirmation dialog, automatized sending stored data) |
| • | Automatic vehicle model renewed (interface connected to the car in the moment of starting the programm SuperVAG KEY) |
| • | Change directory of log files c:\Users\Public\Documents\APOLLO\LOGS\ (2017.1) |
| • | Backups in directory CARSOFT/DATA named with VIN of the car (faster search, 2017.1) |
| • | PDF file names is updated about function name and stored in directory Dokumenty/CARSOFT/PRINT. |
Comfort VW
Added data sets
| • | Adaptation - UDS control units, vehicles VW Golf VII/Skoda Octavia III/etc. TESTED |
| • | Corrected Block of measure values data UDS (10% ) TESTED |
| • | Corrected Block of measure values data, parking aid 1Z0919283, 7E0 Multivan, 7H0 Multivan TESTED |
| • | Corrected Coding, Trailer VW Golf TESTED |
| • | VW Tiguan, SEAT Ateca, Škoda Octavia III facelift, Kodiaq - corrected control unit list TESTED |
Smart function Comfort VW
| • | Set of smart function Bulb configuration (BCM, Bordnetz)
There is up to 32 overview smart function available for every bulb on the car. You can set all the function of apropriate bulb beginning with Fogg light and ending with Headlights right. |
| • | Smart overview function Airbag configuration (airbag)
Displays list of airbags on the car and allows you to activate or deactivate it. |
| • | Smart overview function Installation list (CAN gateway)
Displays list of control units installed and allows you to activate it or deactivate it. |
FLASH
Read/Write/Update VAG EDC16C64 TESTED
Toolbox
| • | Dashbobards VAG NEC UDS, MM Magnetti Marelli 2010-2014 (eeprom read, direct key programming, ...) |
| • | Dashbobards VAG NEC UDS, JCI Johnson Controls 2010-2014 (eeprom read, direct key programming, ...) |
SuperKEY
| • | Immobilizer (dashboard) VAG NEC UDS, MM Magnetti Marelli 2010-2014 (direct key programming) |
| • | Immobilizer (dashboard)VAG NEC UDS, JCI Johnson Controls 2010-2014 (direct key programming) |
| • | Direct key programming works on cars without keyless system only. |
| • | New key programming mode in the Direct key programming (key learning without PIN) : Adding method |
| • | Adding method means, that you can just only add one or more keys without erasing or reprogramming of the old ones. |
This function is used using mark + before the count of the keys.
Works only on dashboards with Direct key programming, par ex. VDO UDS NEC, MM UDS NEC, JCI UDS NEC.
Example :
| • | If you enter as the key count value “2”, then all key positions is erased and 2 keys will be programmed (0 - 2) |
| • | If you enter as the key count value “+2”, then working key positions remain untouched and 2 new keys will be programmed (2-4). Original keys stays working. |
