NEWS AND UPDATES
Firmware: FW 21/102
| • | Supports Windows 8 |
| • | There is no more support for adapters SVG4 a SVG5 (serial number lower than 9999). Those adapters must be replaced. |
| • | Adapter configuration was improved and to configure adapter is now much faster. |
SuperVAG 2012 Environment
| • | Simplifying sending information with communication (so called log files) to HR Carsoft. Just click on the icon at the top of the program and complete description of the problem. Sends log files up to 24 hour old. Computer must be on-line connected to the internet. |
DeTeCtor
| • | New licence, which allows communication with the available control units on supported vehicles (VW Group, PSA Group, selected models of other brands). You can read and erase easily fault memory and on selected models also allows easily reset the service intervals. |
| • | SVG6i adapter is required |
COMFORT VW
New following functions added:
| • | new comfort functions Enabling Monitoring of tire pressure on the cars VW Passat 3C |
| • | new comfort functions Testing the remote control signal for Skoda Fabia II 2010 - |
| • | new comfort functions Remote control learning function for Skoda Fabia II |
Added models:
| • | Skoda Citigo, updated list of control units |
| • | Skoda Fabia facelift 2010-, newly added model |
| • | Skoda Roomster facelift 2010-, newly added model |
| • | Skoda Rapid 2012-, newly added model |
| • | Audi A3 8P 2010-, newly added model |
| • | Volkswagen Golf VII 2012-, newly added model |
| • | Volkswagen Touran facelift 2011-, newly added model |
Added data
• Adding data for block measure values for air condition control unit, Audi Q5, 2009 -
• Completed basic settings for air condition control unit, Audi A3 8P 2003-2008
• Adding data for block measure values for ABS VW Lupo,
• Škoda Fabia II 2010 - central electronic module added table for long coding (including functions daytime lights activation, activation CORNER, activation of cruise control).
Corrections
| • | Fixed a comfort learning function for keys for SEAT Ibiza / Cordoba 1999-2005. |
| • | Fixed data for block measure values for central comfort module for VW Fox |
| • | Fixed a comfort function Testing the remote control signal for VW Fox |
| • | Corrected data for long coding of the central electronic module |
| • | Audi A2, central comfort module - fixed measure values and comfortable remote control learning function, coding added to Help menu. |
| • | Skoda Fabia II 2010 - central electronic module was completed with data for reading measured values, |
New comfort functions transferred to new SuperVAG2010 tool
| • | Idle reset for Felicia 1,3 MPI |
| • | Service interval reset - updated |
| • | Remote controls learning function - updated |
| • | Test of remote control signal - updated |
| • | Key Learning function - Updated |
| • | Reading immobilizer status - updated |
| • | ON and OFF function for transport mode |
| • | Sending a command to clear faults/messages in all control units |
COMFORT PSA
| • |
COMFORT VW (original aplication)
| • | Correction for long coding central electronic module |
TOOLBOX VW
Corrections
| • | Function Read / Write EEPROM memory of dashboard, VDO, K-line is available again |
| • | Fixed function CRC correction in engine eeprom VAG EDC15 |
| • | Fixed function: reading the status of the immobilizer in eeprom VAG EDC15 |
| • | Fixed PIN Reading for the engine control unit MARELLI 2000-2004 if only VINR2 / 3 is available |
| • | PIN Reading on the instrument panel M73 Vxx (if only VINR2 / 3 is available) |
| • | Dashboards 2010 - Reading and writing immobilizer data. New function that allows you to prepare and learn transponder and learning function for keys to the car. Using the collected data a new transpoder can be prepared. |
Writing modified data to the panel, you can learn key (transponder) directly for the car (no need to perform the procedure using the key learning function with all other keys functioned with the specific car).
| • | Preparing the transponder and the editing concrete data/files for those cars is now a new service provided by HR Carsoft Ltd. Supported cars: Skoda Fabia II Facelift 5J 2010 - Skoda Octavia II facelift 1Z 2009 -, 2010 Skoda Yeti - Skoda Superb II 3T 2009 - Volkswagen Polo, 2009 - Volkswagen Golf 2009 - Volkswagen Touran 1T 2010 - Volkswagen Tiguan 5N 2010 - SEAT Altea 2010 - SEAT Leon 2009 - SEAT Ibiza 2009 - SEAT Exeo 2009 – |
New functions
| • | VIN and SKZ transcription in engine control unit VAG EDC15, |
| • | Function for Switching ON status of immobilizer in engine control unit VAG EDC15. |
TOOLBOX PSA
| • | Restored displaying icons for the control unit (CU) EDC15 Peugeot, Renault, KIA. Activation of SPEED2 is required. |
| • | Added control unit EDC15C7 (Peugeot Boxer 2000 -) |
| • | Added control unit EDC15C2 |
FLASH
| • | VW Crafter 2,5TDI, EDC16, corrected writing session |